What is Not Covered This warranty is not transferable and does not cover i cosmetic damage, ii damage due to acts of God, accident, misuse, abuse, negligence, commercial use, or due to improper use, installation, operation or maintenance, iii modification of or to any part of the Product, iv attempted service by anyone other than a Horizon Hobby authorized service center, v Product not purchased from an authorized Horizon dealer, or vi Product not compliant with applicable technical regulations. Horizon reserves the right to inspect any and all Product s involved in a warranty claim. Service or replacement decisions are at the sole discretion of Horizon. Proof of purchase is required for all warranty claims. Further, in no event shall the liability of Horizon exceed the individual price of the Product on which liability is asserted. As Horizon has no control over use, setup, final assembly, modification or misuse, no liability shall be assumed nor accepted for any resulting damage or injury.
|Published (Last):||14 May 2016|
|PDF File Size:||2.71 Mb|
|ePub File Size:||7.54 Mb|
|Price:||Free* [*Free Regsitration Required]|
Today's Posts. Mark Forums Read. Thread Tools. Search this Thread. I don't have the slightest idea how to bind the two together and I'm looking for a little help. Any one have any ideas? I don't have the "5-in-1" component and I just have the transmitter and no manual or any other items.
Any help will be awesome. Thanks, Matt Tener. Reply Like. View Public Profile. Send a private message to KansasFlyer. Find More Posts by KansasFlyer. View iTrader Profile. I don't have an LP5DSM Xmtr nor have I had a chance to use one, but the following link will take you to links to the quick start quice and the manual.
Send a private message to RonR Find More Posts by RonR My Feedback: 3. Send a private message to mimhoff. Find More Posts by mimhoff. Thanks for the great info! Unfortunately, I don't have the binding plug, nor do I know where I would put it. I was given just the transmitter, which has the switches on the front, but just a trainer plug on the back and a charge plug as well. I think I might be hosed! My Feedback: It's the receiver that has to bind to the TX, not the other way around.
Send a private message to fizzwater2. Find More Posts by fizzwater2. Thanks again for everyone's help. I did a little snooping around the BNF P manual and it led me to some new procedures that worked. I installed the battery in the Sukhoi, then held the trainer switch on the transmitter and turned the transmitter on. It binded right up! The Sukhoi is a bit pitchy, but fun.
I would definately advise anyone to utilize a tranmitter with dual rates because in flight it's quite sensitive. It will snap roll when you pull too hard as well. A lot of fun though! Thanks again for the help. The RC community is the best.
Matt- Glad you got it working. Have fun. Thanks the info. The only things is I'm not sure what the 1 switch does, I move it and at least on the Apprentice airplane it seems to do nothing. Send a private message to johnbevington. Find More Posts by johnbevington. Reply Subscribe. Back to Subforum. View Next Unread. Posting Rules. You may not post new threads. BB code is On. Smilies are On. Forum Rules. Show Printable Version. Email this Page. Search this Thread : Advanced Search.
Thread Tools Show Printable Version. Advanced Search. Close X.
E-flite LP5DSM Parkzone Binding
LP5DSM 5-Channel Transmitter, 2.4GHz: BCX2/3
Eflight LP5DSM from heli to plane?