Ademco Keypad Ademco Keypad. Ademco Keypad looks good in design, features and function. The best function of this product is really simple to clean and control. The design and layout are very fantastic that make it really appealing and beauty.
|Published (Last):||28 March 2016|
|PDF File Size:||4.91 Mb|
|ePub File Size:||9.52 Mb|
|Price:||Free* [*Free Regsitration Required]|
Alarm Grid Follow. Full Name Comment goes here. Are you sure you want to Yes No. Be the first to like this. No Downloads. Views Total views. Actions Shares. Embeds 0 No embeds. No notes for slide. Honeywell install-guide 1. Addressesare set via the keypad keys. The keys on the keypads are continuously backlit forconvenience. These The keypad can be set either for an address of , or to thekey pairs may be used to activate panic alarms.
See the non-addressable mode The keypads default address is Refer to the Installation and Setup Guide of the control panel being used for correct address Key pairs activate immediately. The following key pairs are used by the ADEMCO to To change the keypads address, do the following:manually activate silent emergency, audible emergency, 1.
Power up the keypad. Within 60 seconds of power-up, presspersonal emergency, or fire alarms: and hold down the  and  keys at the same time for 3 seconds. The keypads can be surface mounted directly to a wall, or to NOTE: The keypad will not enter address mode if the panela single- or double-gang electrical box.
Remove the case back by pushing down two "snaps. Set the current address to "00": Press  to clear the current "tens" digit. The cursor moves to the "ones" digit2. Route wiring from the control panel through the position.
Press  to clear the current "ones" digit. The opening in the case back. Mount the case back to a wall or electrical box. Enter the keypads address: Enter the proper "tens" digit of the keypads address. The cursor moves to the "ones" digit4. Enter the proper "ones" digit of the keypads the terminal block on the control board. See Wirng address. Note that address "31" sets the keypad to non- Table that follows. Wiring Table 4. Pwr Red about 3 seconds.
The current address is displayed. Press any key to exit, or wait 10 seconds to5. Reattach the keypad to its case back. Sounder:Piezo-electric fire alarm is loud, pulsing single tone;burglary alarm is loud, continuous, dual tone. You just clipped your first slide! Clipping is a handy way to collect important slides you want to go back to later. Now customize the name of a clipboard to store your clips.
Visibility Others can see my Clipboard. Cancel Save.
6148 Fixed Display Keypad
6148 / 6148SP